Engineering Design Of Fuel Reactor Pirolysis Incinerator (IPFR) Processing Plastic Waste into alternative Fuel with Residual Oil Heating

Authors

  • Aditya Wahyu Pratama
  • Ahmad Rofi’i Politeknik Negeri Jember

Abstract

. In Indonesia, plastic waste has become an important problem at this time, because it causes environmental pollution problems. One of which is by converting waste into liquid fuel. Some types of rubbish that we often encounter are plastic bottles such as plastic cups, plastic bottle caps and others, which is one of the types of PP (polypropylene) waste. Polypropylene type plastic is the type of plastic that is most widely used in daily life because it has good mechanical properties with low density, heat and moisture resistance, and has good dimensional stability, Technology  using the method of high temperature (Thermal Cracking). In this study, researchers designed a Thermal cracking device, namely an Incinerator, a plastic waste smelter with high temperature, where the modification of this tool is to use used fuel oil or residual oil. In this study, the researcher analyzed the burning time, the amount of waste mass needed for the melting process in the Incinerator. In this research, a fuel equivalent of 1.5 liters of premium fuel was produced with 10 kg of plastic waste burned in the incinerator with a burning time of 125 minutes of the pyrolysis process, with a combustion temperature of 180-250 degrees Celsius.

References

Kadir. 2012. Kajian Pemanfaatan Sampah Plastik Sebagai Sunber Bahan Bakar Cair. Dinamika Jurnal Ilmiah Teknik mesin. Vol. 3, No. 2. Kendari: Universitas Haluoleo.

Kumar S., Panda, A.K., dan Singh, R.K., 2011, A Review on Tertiary Recycling of High-Density Polyethylene to Fuel, Resources, Conservation and Recycling Vol. 55 893– 910.

A. Lopez, D. M. I, F. L. M, M. C. B and A. A, "Pyrolysis of Municipal Plastic Waste: Influence of Raw Material Composition," no. 30, pp. 620-627, 2010.

Q. Racmawati and W. Herumurti, "Pengolahan Sampah Secara Pirolisis dengan Variasi Rasio Komposisi Sampah dan Jenis Plastik," Jurnal Teknik ITS, vol. IV, no. 1, pp. D(27-29), 2015.

M. F. Nugraha, A. Wahyudi and I. Gunardi, "Pembuatan Fuel dari Liquid Hasil Pirolisis Plastik Polipropilen Melalui Proses Reforming Dengan Katalis NiO/Γ-Al2O3," Jurnal Teknik POMITS, vol. II, no. 2, pp. F(299-302), 2013.

Kurniawan, A. 2012. Mengenal Kode Kemasan Plastik yang Aman dan Tidak http://ngeblogging.wordpress.

Melyna E, Irdoni, I. Zahrina. Tanpa Tahun. Perengkahan Sampah Plastik (HDPE, PP, PS) Menjadi Precursor Bahan Bakar dengan Variasi Perbandingan Bahan Baku/Katalis H-Zeolit. Riau: Universitas Riau.

Muryani. 2016. Kelompok Swadaya Masyarakat (KSM) pengolahan Sampah kelurahan Wlingi. Blitar: Wlingi.

Surono, Budi.U. 2013. Berbagai Metode Konfersi Sampah Plastik Menjadi Bahan Bakar Minyak. Jurnal Teknik Vol. 3 No.1.Yogyakarta: Universitas Janabadra.

Wikipedia. 2016. Macam-Macam Reaktor. 9 April. 2000.

Ramadhan,Aprian (2011), Pengolahan sampah plastik menjadi minyak menggunakan proses pirolisis, Jurnal Ilmiah teknik Lingkungan Vol. 4 no. 1 Universitas Pembangunan Nasional “Veteran” Jawa Timur

Azamataufiq BP, Aditya Wahyu P (2015), Nilai Kalor Bahan bakar Plastik Polypropilene (BBPP) Hasil Pirolisis dengan campuran premium dan octane booster,Jurnal Ilmiah INOVASI, Vol 1 .No.2 edisi Mei-agustus 2016, ISSN 1411-5549

Rahayu Dwi U, DG.Okayadnya, M.Mirwan (2013) , Meningkatkan kinerja Incinerator pada Pemusnahan Limbah Medis di RSUD Dr, Sutomo , Surabaya., Jurnal Ilmiah Teknik Lingkungan UPN Veteran Surabaya.

Fatkur Rhohman, Muslimin Ilham, (2019) , analisis dan Evaluasi rancang bangun Incinerator Sederhana dalam mengelola sampah rumah tangga, Jurnal Mesin Nusantara, Vol 2 No. 1, Juni 2019, hal 52 – 60, teknik Mesin Universitas Nusantara PGRI Kediri, jawa timur.

Dewa Gede AP, Ainul Gurri, Wayan nata Septiadi, (2016), Analisis Unjuk Kerja Bahan Bakar Hasil Pengolahan Oli BekasPada Motor Diesel, Jurnal METTEK vol 2 no. 1, pp 43 – 50 , Teknik Mesin Universitas Udayana.

Muh. Hasbi1, Lilis Laome2, Prinob Aksar3, Ld. Asman Darsono, Pemanfaatan Minyak Oli Bekas sebagai Bahan Bakar alternative, SEMINAR NASIONAL TEKNOLOGI TERAPAN INOVASI DAN REKAYASA (SNT2IR) 2019 PROGRAM PENDIDIKAN VOKASI UNIVERSITAS HALU OLEO

Downloads

Published

2020-12-10

How to Cite

Pratama, A. W. ., & Rofi’i, A. . (2020). Engineering Design Of Fuel Reactor Pirolysis Incinerator (IPFR) Processing Plastic Waste into alternative Fuel with Residual Oil Heating . Food and Agricultural Sciences : Polije Proceedings Series, 3(1), 204–211. Retrieved from https://proceedings.polije.ac.id/index.php/food-science/article/view/166